19765 Tablet PC holder
19765
»Biobased«
Information for use
Intended use
The tablet PC holder is primarily designed for holding a tablet with 155-307 mm dimension. The
clamping prism allows the tablet PC holder to be attached to tubes with a diameter of 7-30 mm.
The inclination can be adjusted to an angle of 90° via the joint. The span can be varied or adju-
sted quickly and easily via a clamping screw on the back.
Foreseeable misapplication
Do not transport the tablet PC holder with the tablet clamped. Do not use the tablet PC holder up-
side down.
General
u
Use a suitable stand: The stand must have sufficient stability and load-bearing capacity. Using
u
the tablet PC holder with an inserted tablet can affect the stability and unbalance the stand.
u
Observe the instructions for use of the stand used.
u
Set up and adjust:
u
● Attach the holder without the tablet to the stand and adjust to the desired position.
u
● The greatest stability is achieved when the tablet PC holder is aligned so that it is flush with
u
●
or overlapping one ot the stand feet.
u
● Loosening the clamping and adjustment screw when the tablet is still clamped, is only per-
u
●
mitted to make small corrections to the position. Increased caution is required when making
u
●
this correction to prevent the unit from falling down unexpectedly.
u
Falling over or dropping the tablet PC holder can cause personal injury and damage to
u
property.
u
There is a risk of crushing between the components due to the possibility of adjustment.
u
The user must be physically and professionally fit.
u
The usage information is an integral part of the product and should be kept for its service life
u
or passed on to any subsequent owner or user.
Warranty
No warranty is given for damage caused by:
u
Non-observance of the usage information and the "General safety and assembly instructions".
u
Unsuitable or improper use.
u
Incorrect installation or commissioning by the buyer or third parties.
u
Natural wear and tear.
u
Careless handling.
u
Improper modifications or repair work by the buyer and third parties.
u
Impact on components of foreign origin.
u
Use of non-original spare parts.
Modifications, additions and conversions that may impair safety are prohibited without the manu-
facturer's approval.
