26792 Bearing plate
- tray for monitors and loudspeakers; suitable for K&M Design monitor stand 26795
- available in 3 variants: 240 x 200 mm / 320 x 280 mm / 420 x 380 mm
Thank you for choosing this product. This instruction manual informs you about the important steps to set up and handle the product.
We recommend to keep the manual in a separate place for a possible later use.
SAFETY NOTES
SET UP INSTRUCTIONS
KÖNIG & MEYER
GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
26792-024-56/26792-032-56/26792-042-56 Rev.08/05/04 03-80-808-00 7/18
A. Depending on the form (width/depth) of the monitor, decide which direction the Bearing plate should be positioned
1
on the stand.
B. Place the countersunk screws M6x16 mm
2
in the drill holes on the plate and screw them into the stand with an Allen Wrench
3
.
C. MONITOR SURFACE
C.
The Monitor can be placed on 4 rubber knobs
4
or 4 brass tips
5
.
C.
Brass tips: Place the tread into the drill hole with the washer
6
and clamp nut
7
and screw it onto the plate.
C.
Rubber knobs: Self-adhesive, remove the protective foil and adhere to the desired locations.
D. Position the monitor on the plate. Check the safety of the installation.
ATTENTION:
to the fact that the monitor is not attached to the tray, it is only placed on the tray, safety measures must be put in place:
- handle bearing plate with care, in particular do not drop it during assembly.
- ensure the screws are properly tightened.
- be sure that the surface is suitable and level.
- Ensure concentric load; protect the monitor from shocks and check regularly that it is properly seated.
- prior to adjusting or moving the stand remove the monitor from the bearing plate.
- the brass tips represent a risk of injury. Remove from the plate when not in use or take protective measures.
Material
Plate: Steel, powder coating, black
Threaded tips: Brass
Screws, washers: Steel, galvanized
Load
max.: 60 kg
Dimensions*
26792-024-56
26792-032-56
26792-042-56
W x D x H Weight
240 x 200 x 5 mm; 1.8 kg
320 x 280 x 5 mm; 3.4 kg
420 x 380 x 5 mm; 6.0 kg
Packaging
PE-Bag
TECHNICAL DATA / SPECIFICATIONS
CHECK, MAINTENANCE, CLEANING
- Pay attention to possible hazards during maintenance work.
- To care for the product, use a damp cloth and a
-
non-abrasive cleaning agent.
FAULT-FINDING (F) and REPAIR (R)
F: Plate wobbles on stand.
F:
R: Inspect the thread and tighten the screws;
F: R:
if no improvement occurs: complain.
F: Monitor wobbles on the plate.
F:
R: Be sure that the monitor is the right size for the plate and
F: R:
that it is placed on the knobs/tips.
F:
R: Check if all 4 thread tips or knobs are installed and
F: R:
if needed install any missing pieces.
