KÖNIG & MEYER
GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
26772-000-56 Rev.02 03-80-852-00 5/18
TECHNICAL DATA
Material
Foot plate, Tray plate: Steel,
powder coating, black
Load
max. 15 kg central load
Dimensions
Base: W x D 214 x 210 mm
Bearing plate: W x D 150 x 170 mm
Height: 167 - 254 mm
Packaging
Box: 270 x 270 x 190 mm
Weight
3.1 kg
26772 Table monitor stand
Attractive table stand for studio monitors and loudspeakers
- Variable height adjustment between 167 and 254 mm
- Adjustable by hand without the use of tools
- Anti-slip stand and de-coupled thanks to the
-
four rubber knobs for the surface and tray.
- Recommended max. weight up to 15 kg
- Tray W x D 150 x 170 mm
SAFETY NOTES
Thank you for choosing this product. The instructions provide directions to all of
the important set up and handling steps. We recommend you keep these
instructions for future reference.
- Maximum centered load: 15 kg
- The surface must be load bearing and even.
- Center the monitor (check placement regularly)
- Any adjustments to the stand (position, height)
-
must be done without the monitor on the stand
- The fact that the product is adjustable, can result in the risk
-
of pinching/wedging:
-
Careful and attentive handling during setup, operation,
-
and disassembly is indispensable
SETUP INSTRUCTIONS
1. COMPONENTS
a.
STAND:
a.1
Footplate -
a.2
Clamping elements -
a.3
Tray
b.
RUBBERIZED KNOBS: strip with 4 self-adhesive rubber knobs ø13 mm
2. MOUNTING
The product comes completely pre-assembled.
2.1
Only the rubber knobs
b
must be adhered to the monitor
2.1
- depending on the dimensions of the monitor
2.1
and as far apart as possible.
USAGE NOTES / FUNCTION
3. HEIGHT ADJUSTMENT
If needed, remove the monitor from the tray
3.1
Hold the tray and...
3.2
...loosen the clamping nut some.
3.3
Adjust to the desired height and...
3.4
...tighten the clamping nut.
4. CLAMPING
The clamping nut is pre-mounted and points forward.
For optical and practical reasons this can also be
placed on the back of the stand.
If needed, remove the monitor from the tray
4.1
Hold the tray
4.2
Unscrew the clamping bolts from each other completely.
4.3
turn the clamping element 180°...
4.4
...and tighten them again;
4.5
In this process be sure that the foot plate pegs are
4.5
placed into the slits of the tray plate.
5. DIMENSIONS
FAULT-FINDING (F) and REPAIR (R)
INSPECTION and MAINTENANCE
F: Installation is not stable
F:
B: Check surface, check rubber knobs, tighten clamps
F: Tray is leaning forward
F:
B: Plate is bent,
F: B:
pegs are not properly placed in the slits of the desk plate
4.5
- Perform workstation maintenance only without the monitor on the tray
-
and be aware of possible risks (fingers wedged/pinched, bumping into
-
the stand, the stand falls over)
- To care for the product, use a damp cloth and a non-abrasive
-
cleaning agent.
1. COMPONENTS
2. MOUNTING
3. HEIGHT ADJUSTMENT
4. CLAMPING
5. DIMENSIONS
