18969 Child’s keyboard stand
- Child-friendly with multiple height and width adjustment.
- Intuitive easy-to-use scissor-leg stand with the so-called „memory effect“ (see USER INSTRUCTIONS).
- Moveable rubber pads can be adjusted for both small and large instruments
- Has all features of the large K&M keyboard stands: solid construction, easy to use, folds for easy transport,
-
high quality surface protection, parquet floor protectors to level unevenness.
- Height: min. 210 / max. 755 mm weight: 3.0 kg.
SAFETY INSTRUCTIONS
Thank you for choosing this product. The instructions take you through all the important steps to set up and use this product.
We recommend retaining the instructions for later use.
- Max. weight capacity 50 kg.
- Ensure the floor is level and suitable to support such a weight.
- There is the obvious danger of trapping fingers, etc. should the product collapse. Be careful when assembling, using and dismantling.
- Check the screw connections are tight before beginning play (you should not be able to move the locknuts by hand, if you can,
-
tighten with a ring spanner).
- The connector struts must be tightly connected at all times.
- The instrument is safest placed on the slip-proof rubber mats, which can be used in two positions.
- The quality parquet protectors do not contain plasticizers. A non-slip mat should be used for highly sensitive floors
-
(e.g. some types of parquet flooring).
ASSEMBLY INSTRUCTIONS
1. Set up the stand so that the bearing tubes (365 mm) are up and the base tubes are down (465 mm).
2. Open the stand.
3. If the floor is uneven adjust the parquet protectors (+/-)
4. Variation A
4.
(=delivery setting)
4.
for normal heights;
4.
the scissor legs setting uses
4.
the upper screw holes.
4.
Variation B
4.
for lower positions;
4.
The scissor legs are connected
4.
through the lower screw holes.
4.
The connectors are mushroom
4.
head bolts M6 x 70 mm (x),
4.
U washers ø18 mm (y)
4.
and locknuts M6 (z).
USER INSTRUCTIONS / FUNCTIONS
The height and width of the assembled stand are determined by
the position of the connector struts. Open and ready to use –
once the stand has been adjusted, it does not need to be re-positioned (memory effect).
5. If you wish to re-set height or width, unscrew the mushroom head bolts M6x15 (w),
5.
U washers ø16 (v) and clamping nuts (u) and reconnect in another pair of holes.
6. Be careful that the hole number is the same (count from inside),
6.
the connected pair are only aligned when the stand is folded
6.
(see Fig. 8.a and 8.b).
540-755 mm
210-680 mm
