18825 Equipment Stand
Versatile:
for sound mixers, monitors, keyboards, amplifiers
Adjustable:
height: 660-915 mm / width: up to 840 mm
Mobile:
uncomplicated setup and disassembly, without tools, easy to
transport packaging dimensions: W x D x H: 80 x 390 x 660 mm
Stable:
long lived steel construction, load bearing weight 50 kg
K&M-Quality: solid workmanship, smooth handling
anti-slip adjustable rubber top for keyboards
balancing end caps for uneven surfaces
SAFETY NOTES
- maximum Load 50 kg.
- be sure that the surface will bear the load and is suitable and level.
- both support arms must be adjusted to the same height.
- the stability is dependent upon the setup width and it should be at least 250 mm, however depending on a the load
-
(weight, extension), b. uneven surfaces (evenness), c. environment (at a public event etc.)
-
Larger distances (max. 840 mm) can be required. If needed, work with the suitable support table.
- ensure that the clamp bolts (see Pos. 9) catch when adjusting the height.
- the fact that the product is collapsible and adjustable, can result in the risk of pinching/wedging. This particularly affects the cross legs
-
(scissor legs) used to set the stand width. Please be sure to pay attention to warning (X).
-
Careful and attentive handling during setup, operation, and disassembly is indispensable.
- the end caps are made of high quality material and to the extent possible free of softening agents.
To protect particularly delicate floors (possibly certain wood floor types) a slip resistant pad should be used, if needed.
USAGE INSTRUCTIONS
STAND SETUP
The stand is completely pre-assembled.
Setup is very easy and does not require tools
1. Setup the stand such that the support
1.
tube (250 mm) are up top and the feet
1.
tubes (385 mm) are on the bottom.
2. Loosen the wing nuts a bit
3. Pull the sides i.e. legs apart to the
3.
desired width: (the width is limited to a
3.
maximum of 840 mm)
3.
NOTE:
3.
The greater the distance, the better the
3.
stability of the stand. We recommend,
3.
not to use any distance that is less than
3.
250 mm. If needed, we recommend the
3.
use of a suitable support table (please
3.
refer to Section: SAFETY NOTES).
4. Re-tighten the wing nuts
5. In the case of uneven surfaces adjust
5.
the balancing end caps (+/-).
To collapse the stand, please follow the
instructions in reverse order.
WARNING:
When pushing the stand legs together, be
sure to do so by placing your hands on the
support tube (Ill. 3).
X. DO NOT place your hands in the cross l
X.
egs (scissor legs) area to avoid the risk of
X.
pinching or wedging your fingers or hands
X.
– please refer to the warning.
Thank you for choosing this product. This instruction manual informs you about the
important steps to set up and handle the product. We recommend to keep the
manual in a separate place for a possible later use.
Width
Limitation
Cross Legs / Scissor Legs
Area
