KÖNIG & MEYER
GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
17605-000-00 Rev.07 03-80-333-00 6/19
17605 Four guitar stand »Roadie«
- ideally secures headstocks using support arms and is ideally suited for uncommon and asymmetrical
-
instrument forms
- securely hold the guitars through specially formed , adjustable support arms, which self-adjust to the headstock
- excellent instrument protection thanks to: a. the rubberized headstock support arms
- excellent instrument protection thanks to:
b. the thick foam cushioning for the protection of the instrument’s body
- collapsible, i.e. very transport friendly
- simple handing for setup and use; tools are not required for assembly
SAFETY NOTES
- Be sure that the surface is suitable, sturdy and level
- Properly setup the guitar stand (ensure that the legs are at a 90°, please refer to the set up instructions)
- The fact that the product is collapsible and adjustable, can result in the risk of pinching/wedging
-
Careful and attentive handling during setup, operation, and disassembly is indispensable.
- The support arms are suitable for almost all headstocks. Due to the wide array of guitar models -
-
exceptions are possible. Please check first (refer to C.)
-
The instrument must always be placed into the support arms with due care. Please ensure that the guitar is placed securely into the
-
stand and that it is placed properly against the cushion.
- The protective covers on the support arms are made of high quality rubberized plastic and to the extent technically possible free of
-
softening agents.
-
Chemical reactions with the, in part, very sensitive guitar coatings were not identified by tests performed by an independent institute.
-
However, due to the softness of some surfaces, in particular nitrocellulose based surfaces, dents can appear on the instruments
-
simply as a result of gravity. These are, however, so minimal, that when compared to the regular wear and tear of an instrument, this
-
can be considered within normal range.
- Other objects than guitars are not permitted (e.g. clothing).
- Only suitable for indoor use
SET UP INSTRUCTIONS
Thank you for choosing this product. This instruction manual informs you about the important steps to set up and handle the product. We recommend to keep
the manual in a separate place for a possible later use.
Setting up the 17605 Guitar Stand is very easy.
All stand components come pre-assembled.
All that needs to be done is to place the stand in position.
1
Loosen the clamp screw so that ...
2
...the foot tube can be turned 90°.
3
Tighten the clamp screw until the foot tube
3
fits snugly into the groove of the base tube.
4
Repeat the directions when installing the second foot.
Disassembly is performed in reverse order.