3.) Mounting on the DJ table
4.) Adjusting the support plate
Maintenance, cleaning and repair
u
Maintenance:
Regularly check if the screw connections are tight.
u
Cleaning:
Use a slightly damp cloth to clean the tray. Do not use chlorinated or abrasive
u
cleaning agents. These will cause damage to the surface and varnish.
u
Repair:
Immediately repair any damage that occurs and stop using the tray. Maintenance
u
work may only be carried out if you have the necessary knowledge. If any parts are missing,
u
contact the manufacturer at www.k-m.de. Here you can find a corresponding spare parts list by
u
entering the article number on the type label. Use this page to reorder missing or damaged
u
components.
To mount the tray on the DJ table, pro-
ceed as follow: Remove the tabletop, ac-
cording to the use and the safety
instructions. Hook the support tube of the
tray into the base tube of the DJ table. In-
sert the carriage bolt from above through
the support and base tube. Slide the was-
her over the carriage bolt from below and
hand-tighten the clamping screw. The tray
can be mounted in three different positi-
ons on the DJ table.
The support plate can also be mounted in three different positions. For this purpose, remove the
cover caps on the back of the support plate. Take out the nut and remove the carriage bolt for-
wards. Hold the support plate and repeat the procedure with the second screw connection. Adjust
to desired position and refit the screws in reverse order.
Adjusting the height: Open the lower clamping
screw, set desired height and retighten the
clamping screw hand.
Adjusting the inclination: Open the upper clam-
ping screw set desired inclination and retighten
the clamping screw hand-tight.
Hinweis: Open the clamping screw at least 1.5
turns so that the locking discs no longer touch
each other when adjusting. When tightening,
make sure that the teeth of the locking disc
interlock.
The inclination is only allowed within the
illustrated range during use. The support plate can be folded for transport.
