15
MOUNTING INSTRUCTIONS
• EN
Quick-assembly without mounting cord
1.
→ Fig. 1a
Take inner chain, lift chain up, push it backwards and spread evenly over the tyre.
2.
→ Fig. 1b
Drive approx. 3/4 of a wheel‘s turn onto the chains. Further mounting like the
rope mounting, point 3.
Mounting anti-skid chain with mounting cord
1.
→ Fig. 2a
Spread out anti-skid chain in front of or behind the tyre and arrange properly.
Tightening lever, tightening spring and tightening chain must face outward! Put
mounting cord at an angle across the top half of the tyre. Hook anti-skid chain
into mounting hook.
2.
→ Fig. 2b
Drive slowly one complete turn of the wheel onto the chain, thereby pulling the
chain onto the tyre. Loosen anti-skid chain by unhooking the mounting hook.
Remove mounting cable.
3.
→ Fig. 3
Connect side chain on the inner side of the wheel, hook closing hook into the link
or ring - then repeat the procedure on the outside of the wheel.
Note -
Check after connection: chain strands must not be twisted.
4.
→ Fig. 4
Tighten tension chain on the outside of the wheel and insert tension lever into
the next link of the tension chain.
5.
→ Fig. 5
After about 50m, stop to retighten the chain.
Note for dual chains
Mounting and demounting is carried out in the same order as with single chains.
Note -
If it is difficult to hook in the closing hook when mounting the dual chain, e.g. in
the case of thick-studded tyres, the vehicle should be moved forward or backward approx.
one wheel’s turn so that the chain mesh is properly arranged before hooking in the central
hook.
