Measuring the blood pressure
1.
To switch on the device, press the start/stop button. The display shows all display items.
2.
The monitor starts to seek zero pressure.
3.
The monitor inflates the cuff until there is sufficient cuff pressure.
4.
The monitor slowly releases air from the cuff and carries out the measurement. The display
shows the systolic blood pressure, the diastolic blood pressure and the pulse rate. The
results are stored in the memory automatically.
5.
To switch off the device, press the start/stop button again.
Reading measurements from the memory
1.
Press the memory button. The display shows the amount of results in the memory,
followed by the most recent result.
2.
Repeatedly press the up button or the down button to navigate through the results.
Deleting measurements from the memory
•
When the display shows a result, press and hold the memory button for 3 seconds. All
results in the memory are deleted.
Error codes
Error code
Cause
Solution
Bluetooth indicator
+ Error indicator
Data communication error.
Make sure that Bluetooth is activated on
your mobile device.
Make sure that your mobile device is
within the Bluetooth range.
E2
The cuff is too tight during
inflation.
Apply the cuff correctly and measure
again.
E3
The cuff pressure is too high.
Relax for a moment and measure again
after 5 minutes.
E9
The device has not been activated.
Reactivate the device.
E10 / E11
The device has detected motion
during measurement.
Relax for a moment and measure again
after 5 minutes.
E20
The device does not detect the
pulse signal.
Loosen the clothing on the arm and
measure again.
E21
Measurement error.
Relax for a moment and measure again
after 5 minutes.
EExx
Calibration error.
Measure again after 5 minutes. If the
display still shows the error code, contact
the local distributor or the factory.
Cleaning and maintenance
Warning!
•
Do not use cleaning solvents or abrasives.
•
Do not clean the inside of the device.
•
Do not attempt to repair the device. If the device does not operate correctly, replace it
with a new device.
•
Clean the outside of the device using a soft, damp cloth.
•
If you use the device frequently, disinfect the cuff at least twice a week. Apply ethyl
alcohol (75-90%) to a soft cloth, wipe the inner side of the cuff with the cloth and allow
the cuff to dry naturally.
•
Clean the outside of the device using a soft, damp cloth.
•
If you use the device frequently, disinfect the cuff at least twice a week. Apply ethyl
alcohol (75-90%) to a soft cloth, wipe the inner side of the cuff with the cloth and allow
the cuff to dry naturally.
•
Clean the outside of the device using a soft, damp cloth.
•
If you use the device frequently, disinfect the cuff at least twice a week. Apply ethyl
alcohol (75-90%) to a soft cloth, wipe the inner side of the cuff with the cloth and allow
the cuff to dry naturally.
w w w . e k t
2
. c o m
Electronics
Katrangi
Trading