KONICS KRN1000 SERIES, User Manual

Page: 19 / 86

2 Specifications
© Copyright Reserved KONICS Co., Ltd. 19
※ 2.
◎
At room temperature (23
℃
± 5
℃
)

RTD Cu50Ω (-200≤T≤200): (±0.1% F.S. or ±1.5
℃
, select the higher one) ±1-digit

RTD DPt50Ω (-200≤T≤500): (±0.1% F.S. or ±1.5
℃
, select the higher one) ±1-digit

Thermocouple R, S, C, G type
(0≤T≤100): (±0.1% F.S. or ±4.0
℃
, select the higher one)
±1-digit

Thermocouple U, T type (-
100≤T≤400): (±0.1% F.S. or ±2.0
℃
, select the higher one)
±1-digit

Thermocouple B type, below 400
℃
: There is no accuracy standards.

All thermocouples, below -100
℃
: (±0.3% F.S. or ±4.0
℃
, select the higher one) ±1-digit
◎
Out of room temperature range

RTD Cu50Ω (-200≤T≤200): (±0.2% F.S. or ±3.0
℃
, select the higher one) ±1-digit

RTD DPt50Ω (-200≤T≤500): (±0.2% F.S. or ±3.0
℃
, select the higher one) ±1-digit
※ 3.
Input/Output is different by option. Refer to ‘1.3 Ordering information’.
※ 4.
For supplying power for transmitter, it is recommened to use shield cable to reduce noise.
※ 5.
RS422/485, ethernet, USB device communication outputs are not used at the same time.
※
If sensor input line is longer, it is recommended to use shield cable to reduce noise.
Before the wiring, turn OFF the unit.
Be sure that the polarity of power for transmitter. If not, it may cause product damage.
When supplying the over voltage at sensor input, it may cause product damage.