E-3
V. Punch hole position adjustment
1. Make a copy in the punch mode.
(Refer to the user’s guide (copy operations))
2. Measure width A on the copy and check to see if
the measured dimension falls within the specified
range.
<North America: 2 holes, 3 holes>
Specifications: 9.5 ± 1.0 mm
<Europe: 4 holes>
Specifications: 11 ± 1.0 mm
<Sweden: 4 holes>
Specifications: 10.5 ± 1.0 mm
• If the measured width A outside the specified
range, perform the following procedure to punch
hole position adjustment.
3. Display the Service Mode screen.
(For details of how to display the Service Mode
screen, see the service manual.)
4. Touch “Finisher.”
5. Touch “FS-FN adjustment.”
6. Touch “Punch Horizontal Position.”
7. Set the correction value using the
/
keys.
• To make width A wider, enter a positive value.
• To make width A narrower, enter a negative
value.
8. Touch “END.”
9. Touch “OK.”
10. Touch “Exit” on the Service Mode screen.
11. Make a copy and check the punch hole positions
again.
VI. Punch regist loop size adjustment
1. Make a copy in the punch mode.
(Refer to the user’s guide (copy operations))
2. Check the tilt of the output paper.
• If it tilts, follow the procedures below for punch
loop adjustment.
3. Display the Service Mode screen.
(For details of how to display the Service Mode
screen, see the service manual.)
4. Touch “Finisher.”
5. Touch “FS-FN adjustment.”
6. Touch “Punch Regist Loop Size.”
7. Set the correction value using the
/
keys.
• To make loop length larger, enter a positive value.
• To make loop length smaller, enter a negative
value.
8. Touch “END.”
9. Touch “OK.”
10. Touch “Exit” on the Service Mode screen.
11. Make a copy again and check the deviance of
punch hole position.
4512IXE057DA
<North America:
2 holes>
<North America:
3 holes>
A
<Europe: 4 holes>
<Sweden: 4 holes>
A
4512IXC056DA
A
A
4512IXE062DA
4512IXE061DA
A10E-9550-01E.fm 3 ページ ２００９年７月２日 木曜日 午後６時２３分