Loading Paper (continued)
- 46 -
Maintenance & Supplies
Loading Tabbed Sheets in Multi-Sheet Bypass Tray
Load offset tabbed sheets so that the tab extensions are on the right at the rear (not front) of
the tray. The top sheet is designated face up as the first tab of the finished set. Subsequent
offset tab sheets follow in sequence. The tab extension width should be 12.5 mm or less.
When loading tabbed sheets in the Multi-sheet bypass tray, be sure to specify the paper type
as Tab paper on the Paper Type/Size Setting Screen; otherwise mishandled paper may occur.
3 FINISHED SETS
ONE FINISHED SET
Example: 9 Tabbed sheets loaded in position for 3 finished sets.
Example: 3 Tabbed sheets loaded in position for one finished set.
Section 1
Introduction
3rd TAB
2nd TAB
1st TAB
Printed
side
Section 1
Introduction
Section 1
Introduction
Section 1
Introduction
1st TAB
2nd TAB
3rd TAB
2nd TAB
3rd TAB
Section 1
Introduction
1st TAB
Rear
Front
Rear
Front
Section 1
Introduction
Section 1
Introduction
Section 1
Introduction
3rd TABS
2nd TABS
1st TABS
Printed
side
DP85v1.book Page 46 Wednesday, February 12, 2003 4:09 PM
Summary of Contents for DP-85
Page 62: ......
