Konica Minolta CS-7, Operation Manual

Page: 283 / 424

283
Chapter 7
7 .10 Mammogram exposure
This section describes the screen structure and proce-
dure for mammogram exposure.
IMPORTANT •••••••••••••••••••••••••••••••••••••
• For United States of America, this device is not intend-
ed to use for Mammography .
• If the mammogram print button on the patient registra-
tion and list screens are set to [Mammo Print OFF],
change the setting go [Mammo Print ON].
•••••••••••••••••••••••••••••••••••••••••••••••••••••
7 .10 .1 Screen structure
The screen structure for the adjustment of the position
of the right and left breast images in mammogram ex -
posure is as follows .
(3)
(1)
(2) (2)
(5)
(4)
Number Name Functions
(1)
Image preview
area
Mammogram images are
previewed in this area .
(2)
Vertical position-
ing button
Adjust the position of the im-
ages in the vertical direction .
Operate the right and left
vertical positioning buttons
to adjust the position of the
right and left images, respec-
tively .
Number Name Functions
(3)
Segment flip but -
ton
Replaces the right and left
images with each other . The
images are replaced every
time you press the button .
(4) Cancel button
Cancels outputting image in
AB format .
(5) OK button
Outputs mammogram im-
ages in AB format .
7 .10 .2 Exposure
The procedure for mammogram exposure is as follows.
The procedure is explained using barcode registration
as an example.
IMPORTANT •••••••••••••••••••••••••••••••••••••
• Using EF processing for mammogram images (stan-
dard processing) may produce artifacts in the high
contrast area due to strong edge effect, which is char -
acteristic of this processing . You should use hybrid
processing for mammogram images in order to avoid
such phenomena from appearing on the chest wall .
•••••••••••••••••••••••••••••••••••••••••••••••••••••
1
Select or register the examination for
which mammogram exposure is to be
conducted .
• In the case of list screen, select the examination.
• In the case of patient registration screen, regis-
ter the examination.
• Press [Perform].
• The body part selection screen is displayed .
• If linked with host system such as RIS, the ex -
posure screen is displayed .
→ Go to step 4