Konica Minolta BIZHUB C353P, User Manual

Page: 458 / 516

C353P 14-5
Authentication unit (Biometric type AU-101)
14
14.4 Using authentication unit (Biometric type) AU-101
In order to use this device, user finger vein patterns must first be registered with the machine. A registered
user can print a print job after completing authentication with their finger vein patterns. The following
procedures describe how to specify the necessary settings on the machine and register users.
2
Note
Align the index finger with the indentation and notch in the scanner, and then position the finger so that
the tip lightly touches the edge of the scanner. Place your thumb and middle finger down to hold this
device in place on both sides, and avoid moving the index finger being used for authentication.
2
Reminder
Do not place any object other than your finger in the scanner of this device while scanning, otherwise
the device may malfunction.
Do not disconnect the cable connecting the device to the computer while scanning, otherwise the
system may become unstable.
14.4.1 Positioning your finger
1
Lightly stretch out your fingers, and then position the finger to be registered or authenticated on this
device.
2
Align the tip of the finger with the notch, and lightly position the finger so that the tab can be felt at the
tip of the finger.
2
Note
If registration or authentication is not possible, check for the following. Remove the finger from this
device, and then reposition it correctly.