Konica Minolta bizhub C200, User Manual

Page: 32 / 268

C200 1-18
Before making copies
1
!
Detail
The length of time until the automatic panel reset operation is performed and whether or not it is
performed can be set from Utility mode. For details, refer to
"System Settings" on page 11-14 .
1.3.5 Automatically conserving energy (Low Power mode)
If no operation is performed for a specified length of time, the touch panel goes off and the machine
automatically enters a mode where it conserves energy.
This is the Low Power mode.
The machine can receive jobs even while it is in Low Power mode.
As the factory default, the machine enters Low Power mode after 10 minutes.
To recover from Low Power mode
% Press the key in the control panel or touch the touch panel.
–
The machine will also recover from Low Power mode when originals are loaded into the ADF or
when the ADF or original cover is opened.
– The touch panel is turned on, and the machine starts warming up.
!
Detail
The length of time until the machine enters Low Power mode can be changed.
For details, refer to
"System Settings" on page 11-14 .
1.3.6 Automatically conserving energy (Sleep mode)
If no operation is performed for a specified length of time, the machine automatically enters a mode where it
conserves energy.
Although the machine conserves more energy in Sleep mode than in Low Power mode, the machine must
warm up when Sleep mode is canceled to begin printing again, therefore taking more preparation time than
Low Power mode.
As the factory default, the machine enters Sleep mode after 20 minute.
To recover from Sleep mode
% Press the key in the control panel or touch the touch panel.
–
The machine will also recover from Sleep mode when originals are loaded into the ADF or when the
ADF or original cover is opened.
– The touch panel is turned on, and the machine starts warming up.
!
Detail
As a default, the machine enters Low Power mode if no operation is performed for 10 minutes, and then
the machine enters Sleep mode after 20 minutes have elapsed.
The length of time until the machine enters Sleep mode can be changed. For details, refer to
"System
Settings" on page 11-14 .