Konica Minolta bizhub 308e, Quick Manual

Page: 19 / 214

bizhub 658e/558e/458e/368e/308e 1-11
1.3 Safety information 1
Consumables
WARNING
Descriptions Graphic symbols
Do not throw toner or a container that contains toner (e.g., toner car-
tridge, developing unit and Waste Toner Box) into an open flame. The hot
toner may scatter and cause burns or other damage.
CAUTION
Descriptions Graphic symbols
Do not leave toner-related parts (e.g., toner cartridge, developing unit
and Waste Toner Box) within easy reach of children. Licking any of these
parts or ingesting toner could damage your health.
Do not store toner-related parts (e.g., toner cartridge, developing unit and
Waste Toner Box) near devices susceptible to magnetism, such as pre-
cision equipment and data storage devices, otherwise they may malfunc-
tion. They could cause these products to malfunction.
Do not force open the toner-related parts (e.g., toner cartridge, develop-
ing unit and Waste Toner Box). If toner tumbles from the toner bottle, take
utmost care to avoid inhaling it or even getting skin contact.
If toner lands on your skin or clothing, wash thoroughly with soap and wa-
ter.
If you inhale toner, move to a place with fresh air and gargle with a lot of
water repeatedly. Should you get symptoms such as coughing, seek
medical advice.
If you get toner into your eyes, immediately rinse them with running water
for over 15 minutes. Seek medical advice if irritation persists.
If you swallow toner, rinse out your mouth and drink a few glasses of wa-
ter. Seek medical advice if necessary.
Never touch the electrical contacts of the units (e.g., toner cartridge and
developing unit), as an electrostatic discharge may damage the product.
Before handling, see the user documentation for the safety information.
<If instructed to replace the fusing unit>
The fusing section is extremely hot. Before replacing the fusing unit, be
sure to open doors and covers of the machine. Then, leave the machine
to stand idle for a specified period of time and make sure that the fusing
section has cooled down to room temperature. Failure to follow these in-
structions could result in a burn.