Konica Minolta Bizhub 222, Service Manual, Page: 203 / 846

10. Tech. Rep. Mode Field Service Ver. 1.0 Dec. 2008
164
bizhub 362/282/222
ADJUSTMENT/
SETTING
10.3.7 Finisher
A. Punch Stop Position
B. Punch Loop Adjustment
10.3.8 Trail Erase (Dup)
10.3.9 Internet ISW
• By using this setting, the firmware stored in the server can be downloaded over internet
for upgrading.
• For details for upgrading the firmware, refer to “Firmware rewriting by the Internet ISW” in
the MAINTENANCE section.
See P.45
A. Login name
B. Password
Functions • To adjust the paper stop position for punching.
Use • To adjust the punch position.
Setting/
Procedure See P.32 of the FS-530/PU-501/OT-602 service manual.
Functions • To adjust the length of the loop for correcting skew during punching.
Use • To correct any skew in the punch position.
Setting/
Procedure See P.33 of the FS-530/PU-501/OT-602 service manual.
Functions
• To set the adjustment value for the amount of erase on the trailing edge for 2-sided
printing.
Use
• The amount erased at the trailing edge of the second side of a 2-sided print is the Trail-
ing setting for Edge Erase + Duplex Trailing Erase setting.
Setting/
Procedure • The default setting is “2 mm”.
• The adjustment range is 0 to 5 mm.
Functions
• To register the login name for accessing the program server where firmware is to be
stored.
Use
Setting/
Procedure 1. Select [Login name].
2. Enter the login name (up to 64 one-byte characters) on the on-screen keyboard.
Functions
• To register the password for accessing the program server where firmware is to be
stored.
Use
Setting/
Procedure
1. Select [New Password].
2. Enter the password (up to 64 characters) on the on-screen keyboard, and touch
[Enter].
3. Select [Confirm New Password].
4. Enter the password (up to 64 characters) on the on-screen keyboard again, and touch
[Enter].
5. Touch [Enter].