Konica Minolta AccurioLabel 230, Quick Manual, Page: 178 / 194

6-28 AccurioLabel 230
How to reset emergency stop 6 6.8
6.8 How to reset emergency stop
This section describes how to reset emergency stop. Proceed with the procedure until restoration.
Tips
Emergency stop applies if you press EMERGENCY STOP of Roll Winder RW-110 / Roll Winder RW-210
while this machine is in operation. You can also apply emergency stop by opening the safety door or safety
cover.
1
Turn EMERGENCY STOP of Roll Winder RW-110 and Roll Winder RW-210 to the right.
2
Press the sub power switch on the upper side of Roll Winder RW-210 .
3
Open and close the front door of the main body.
%
If it cannot be restored even after this procedure, proceed to the next procedure.
4
Turn OFF and then ON the sub power switch of the main body.
%
For how to turn on and off the power, refer to page 2-3.
%
If it cannot be restored even after this procedure, proceed to the next procedure.
5
Turn OFF the sub power switch of the main body, then turn OFF the main power switch.
%
For how to turn off the power, refer to page 2-3.
6
Turn ON the main power switch of the main body, then turn ON the sub power switch.
%
For details on how to turn on the power, refer to page 1-1.
%
If it cannot be restored even after this procedure, proceed to the next procedure.
7
Remove the paper from inside the main body.
% For instructions on how to remove the paper, refer to page 6-13.
6.9 If you have forgotten the administrator password
The administrator password is set to "00000000" by factory default.
If the administrator password is changed, contact your service representative.