Konica Minolta 0902, Service Manual

Page: 258 / 302

Chapter 6 Adjustment
6-6
6.3 Adjustment of Justifier Motor
Adjust the justifier (distance justifier guide moves to fix the cassette) after replacing the justifier
mechanism (justifier motor, justifier guide, justifier belt, etc.).
Work outline
Listed below are the number of people and the rough standard of work hours required for performing the
works described in this section.
Requirements
Shown below are the tools requiring to be prepared in addition to the standard tools before performing the
works in this section.
Adjustment method
1
See " Removal Procedures (Page 5-6)" in "5.2.3 Removing/Installing the Exterior Panel and
Insertion Unit" to remove the first front panel.
2
Insert the interlock release key into the interlock
switch.
3
Turn the power ON.
4
Start the service tool and display the [Adjustment]
panel in [Unit Test] screen.
Personnel
Number
Work Hours (steps 2 to 11)
1
No. Tool No. Tool
1 Standard cassette (14 x 14 inches) 2 Interlock release key
Caution
•
Be sure to turn off the power supply circuit breaker and unplug the power cable from the
equipment whenever you disassemble/assemble the equipment.
•
When operating inside the equipment with interlock released and power ON, be aware
against the electrification and pinching.
Second Front Side
Note
Current value right after the "Adjustment"
panel was displayed is in the "Amount of
Justification".