Konica Minolta 0902, Service Manual

Page: 237 / 302

Chapter 5 Disassembly and Assembly
5-117
3
Unplug all the cables connected to the MDU.
4
Remove the MDU.
•
6 hex/Phillips-head screws (M3 x 6)
5
Install the new MDU.
•
6 hex/Phillips-head screws (M3 x 6)
6
Connect the cables removed in Step 3 to the
MDU.
•
CN1 (MCN1: cable)
•
CN2 (MCN2: cable)
•
CN3 (MCN3: cable)
•
CN4 (MCN4: cable)
•
CN5 (MCN5: cable)
•
CN6 (MCN6: cable)
•
CN7 (MCN7: cable)
•
CN8 (MCN8: cable)
•
CN9 (MCN9: cable)
•
CN11 (MCN11: cable)
7
Install the circuit board cover that was removed in
Step 2 .
•
3 screws (M3 x 6)
8
See " Installation Procedures (Page 5-8)" in "5.2.3 Removing/Installing the Exterior Panel
and Insertion Unit" to install the first front back panel.
Now, you have finished with the procedures to replace the MDU.
CN7
CN3
CN4
CN9
CN11
CN8
CN5
CN6
CN1
CN2
First Front Back Side
Caution
When removing the connector, hold a notch
on the connector without pulling a cable.
Giving a strong pull to the cable may cause
it to be broken.