Konica Minolta 0902, Service Manual

Page: 200 / 302

Chapter 5 Disassembly and Assembly
5-80
5
Connect the cables removed in Step 2 to the
LMC.
•
CN1 (ACN1: cable)
•
CN2 (ACN2: cable)
•
CN301 (ACN301: cable)
•
CN302 (ACN302: cable)
•
CN303 (ACN303: cable)
•
CN304 (ACN304: cable)
•
CN4 (ACN4: cable)
•
CN5 (ACN5: cable)
•
CN6 (ACN6: cable)
•
CN7 (ACN7: cable)
•
CN8 (ACN8: cable)
•
CN9 (ACN9: cable)
•
J1 (AJ1: cable)
6
See "5.6.1 Replacing the LMD (Page 5-78)" to install the LMD.
Now, you have finished with the procedures to replace the LMC.
5.6.3 Replacing the Inverter
This section describes the instructions on how to replace the inverter.
Work outline
Listed below are the number of people and the rough standard of work hours required for performing the
works described in this section.
Requirements
The works in this section can be performed using only the standard tools.
1
See " Removal Procedures (Page 5-11)" in "5.2.5 Removing/Installing the Optical Unit" to
remove the optical unit.
Place the removed optical unit in a level and stable place with it kept stood.
2
Unplug all cables from the inverter.
3
Remove the inverter.
•
1 screw (M3 x 12)
•
1 collar for each (3 locations excluding A in the figure)
4
Install the new inverter.
•
1 screw (M3 x 12)
•
1 collar for each (3 locations excluding A in the figure)
Caution
•
Be sure to turn off the power supply circuit breaker and unplug the power cable from the
equipment whenever you disassemble/assemble the equipment.
•
Be careful when handling the optical unit not to send a shock wave to it, that is composed
of precision parts.
Personnel
Number
Work Hours (steps 2 to 5)
1
CN1 CN2
A
Caution
When removing the connector, hold a notch
on the connector without pulling a cable.
Giving a strong pull to the cable may cause
it to be broken.