Konica Minolta 0902, Service Manual

Page: 173 / 302

Chapter 5 Disassembly and Assembly
5-53
5
Connect the cable to the new lock HP sensor.
•
Connector (JP45)
6
Install the lock HP sensor.
7
See " Installation Procedures (Page 5-8)" in "5.2.3 Removing/Installing the Exterior Panel
and Insertion Unit" to install the first front panel and the second front back panel.
Now, you have finished with the procedures to replace the lock HP sensor.
5.4.9 Replacing the Lock Motor
This section describes the instructions on how to replace the Lock Motor.
Work outline
Listed below are the number of people and the rough standard of work hours required for performing the
works described in this section.
Requirements
The works in this section can be performed using only the standard tools.
1
See " Removal Procedures (Page 5-6)" in "5.2.3 Removing/Installing the Exterior Panel and
Insertion Unit" to remove the first front panel.
2
Remove the connector (JP16).
3
Remove the lock release motor unit assembly.
•
2 screws (M4 x 8)
Caution
Be sure to turn off the power supply circuit breaker and unplug the power cable from the
equipment whenever you disassemble/assemble the equipment.
Personnel
Number
Work Hours (steps 2 to 9)
1
JP16
First Front Side
Caution
When removing the connector, hold a notch
on the connector without pulling a cable.
Giving a strong pull to the cable may cause
it to be broken.