Konica Minolta 0902, Service Manual

Page: 130 / 302

Chapter 5 Disassembly and Assembly
5-10
5.2.4 Removing/Installing the Second Front Door
This section describes the instructions on how to remove and install the second front door.
Requirements
The works in this section can be performed using only the standard tools.
Removal Procedures
Work outline
Listed below are the number of people and the rough standard of work hours required for performing the
works described in this section.
1
See " Removal Procedures (Page 5-6)" in "5.2.3 Removing/Installing the Exterior Panel and
Insertion Unit" to remove the exterior panel and insertion unit.
2
Remove the fulcrum bracket assembly, while
supporting the second front door.
•
1 hex/Phillips-head screw (M4 x 8)
3
Remove the second front door from the lower pin.
Now, you have finished with the procedures to remove the second front door.
Installation Procedures
Work outline
Listed below are the number of people and the rough standard of work hours required for performing the
works described in this section.
1
Insert the second front door into the lower pin.
2
Install the fulcrum bracket assembly.
•
1 hex/Phillips-head screw (M4 x 8)
3
See " Installation Procedures (Page 5-8)" in "5.2.3 Removing/Installing the Exterior Panel
and Insertion Unit" to remove the exterior panel and insertion unit.
Now, you have finished with the procedures to install the second front door.
Caution
Be sure to turn off the power supply circuit breaker and unplug the power cable from the
equipment whenever you disassemble/assemble the equipment.
Personnel
Number
Work Hours (steps 2 to 3)
1
Second Front Side
Personnel
Number
Work Hours (steps 1 to 2)
1