Kongsberg XPR 100, Operator'S Manual

Page: 14 / 48

Seatex XPR 100
Operating procedures
Confirming that the system is active
The
Active
button toggles the Sensor Unit between
Active
and
Standby
mode.
The LED is lit (green light) when in
Active
mode (normal operation).
In
Standby
mode (LED is grey), the Sensor Unit will not emit any laser
pulses. It is recommended that the system is switched to
Standby
mode
when not in operation.
Related topics
• Active on page 22
Selecting a target
By selecting a target you specify the frequency pair and address code you want to
use. If you want to use a specific pair and address code, you must create a new target
before you can select it.
Context
The Sensor Unit on the shuttle tanker must be set to the same frequency pair and address
code as on the FPSO/FSU. This is done by selecting a target.
Procedure
1 Select the
System menu
button, , to open the
System
menu.
2 Select
Target
.
3
Select the preferred target site from the list.
12
XPR-D-User/1.0