Kongsberg Simrad TV80, Reference Manual

Page: 127 / 356

406388/F
125
Every interface is presented as a small "block diagram".
Note
Just adding an external device does not mean it is properly working. It is very
important that any serial line between the TV80 system and any external system
is setup correctly with identical parameters at each end. The
UDP Configuration
dialog box allows you to set up the IP address and ports to receive data from an
external device.
6 Select the LAN port icon in the “block diagram” to open the
UDP Configuration
dialog box.
7 Set up the relevant port parameters.
8 Select
OK
to save the selected settings and close the dialog box.
Related topics
SR Connectivity dialog box, page 287
Select Input (LAN) dialog box, page 286
UDP Configuration dialog box, page 304
Serial Port Setup dialog box, page 290
Port Monitor dialog box, page 289
Navigation dialog box, page 242
Setting up the input of a navigation system (GPS) on a serial line, page 125
Setting up the input of a navigation system (GPS) on a
serial line
In order to receive information from an external navigation sensor, you must choose
which communication port to use, and which datagram formats to read.
Context
For the TV80 system to use and offer correct navigational information, one or more
external sensors must be connected. Typical sensors are those providing navigational
information (heading, speed or geographical position). In most cases a suitable sensor is
already installed on the vessel.
The TV80 must be set up to receive the information from these sensors. You must select
which port to use, and set up the various communication parameters.
When you need to use Ethernet to communicate with an external sensor or peripheral
system, you must add a LAN Port and select the relevant system.
Procedure
1 On the
Setup
menu, select
Installation
.
Observe that the
Installation
dialog box opens.
Operating procedures