Kongsberg Simrad ST90, Reference Manual, Page: 507 / 690

442704/A
505
reference units, or other hydroacoustic systems. If you have enabled
Auto Update
, the
text box is continuously updated with new information.
Auto Update
When this function is activated, the relevant text box is continuously updated with
new information. If you wish to "freeze" the information for further investigation,
deactivate to disable the automatic update.
Hex Display
Select this to show the information in the relevant text box in hexadecimal format.
Delete
This function clears the text box to allow a new stream of communication data to
start on a blank page.
Current Port
This box identifies the port you are currently monitoring.
Tip
If you wish to change your attention to a different serial or LAN port, you can choose
the communication port here instead of returning to
I/O Setup
.
Related topics
Setting up the interfaces to peripheral devices, page 195
I/O Setup page, page 516
Functions and dialog boxes, page 416
Secondary functions and dialog boxes, page 494
Messages dialog box
The
Messages
dialog box allows you to read and acknowledge the messages.
How to open
To open the
Messages
dialog box, select
Messages
on the top bar. When a new
message is issued by the ST90 system,
Messages
on the top bar will flash. The
colour of the triangle reflects the severity of the most serious message. If you hold
the cursor over the triangle, a short list of the current messages is shown.
Functions and dialog boxes