Kongsberg Simrad ST90, Reference Manual

Page: 186 / 690

184
442704/A
6 If you want to check the data flow on the selected port, select
Monitor
.
In order to see this data traffic, your ST90 system must be active and transmitting
information to the peripheral system.
The
Port Monitor
dialog box provides one text box for incoming messages (
Rx Data
),
and one for outgoing messages (
Tx Data
). Use these boxes and your knowledge of the
data communication to investigate the datagrams. The
Port Monitor
dialog box is a
tool for debugging purposes. It is neither required nor intended for normal operation of
the ST90 system.
7 Select
Apply
and then
Close
to save all the parameters and close the
Output
dialog box.
Related topics
Operating procedures, page 79
Exporting sensor data, marker positions and technical information, page 181
Relay Output page, page 525
Exporting technical information
Exporting technical information from the ST90 system to a hard disk or USB flash drive is
often useful. Both during normal use, and perhaps preferably during software and hardware
troubleshooting, it can be helpful to share information.
Prerequisites
It is assumed that you are familiar with the Microsoft ® operating system utilities for file
handling.
You need a data storage device. This is typically a large capacity USB flash drive or a
small portable hard disk. You can also connect the computer to a network, and copy the
files to a server.
Context
The
Export
dialog box allows you to export user settings, configuration files, message logs
and information mainly related to hardware and software troubleshooting. You are provided
with a list of file types to export. You must specify
where these files shall be saved.
Procedure
1 Insert the USB flash drive.
2 Open the
Setup
menu.
3 Select
Export
to open the dialog box.
4 Select the information you wish to export.
Simrad ST90 Reference Manual