Kongsberg Simrad EK80, Installation Manual

Page: 254 / 354

252
394149/D
This delay parameter is used differently depending on the chosen synchronization
mode.
• Stand-alone
The
Synchronization Delay
setting is not applicable when synchronization is
switched off.
• Master
In Master mode, the EK80 waits for the delay time after the external trigger
signal has been sent to the slaves before transmitting the ping. This is often
referred to as a
pre-trigger .
Note
This delay will only work when the synchronization is set up using a serial port.
• Slave
In Slave mode, the EK80 waits for the delay time after the external trigger signal
has arrived before transmitting the ping. This is often referred to as a post-trigger .
8 From the list of ports available, select
Synchronization Port
.
This is the interface port currently used to transmit or receive synchronization
signals. It must be an RS-232 serial port. Since the synchronization function only
uses the
Request To Send (RTS) and Clear To Send (CTS) signals on a serial port,
you can use a port that is already used for other purposes. For the same reason,
you do not need to define any baud rate.
9 At the bottom of the page, select
Apply
to save your settings.
10 Continue your work in the
Installation
dialog box, or select
OK
to close it.
Related topics
Setting up the EK80 in a synchronized system, page 126
Cable layout and interconnections, page 85
Interfacing peripheral equipment, page 228
Synchronizing the EK80 by means of the Auxiliary port
The Wide Band Transceiver (WBT) offers an
Auxiliary
port that can be used for
synchronisation purposes. This synchronization method may be more stable that the
traditional CTS/RTS connection to a serial port.
Prerequisites
Unless the physical connections already have been made with a suitable cable, you
need the following items:
• Cable
• Plug
Simrad EK80 Installation Manual