Kongsberg Simrad CP200-5C, Installation Manual

Page: 90 / 110

88
484164/A
2 Make sure that a compatible motion reference unit (MRU) is connected to the echo
sounder.
Note
ADCP operations cannot take place without input from a motion sensor. The input must
be provided on the KM Binary datagram format. KM Binary is a proprietary datagram
format created by Kongsberg Maritime for general use. This format has very high
resolution on timing and sensor parameters.
3 Install the CP200-5C transducer in the echo sounder user interface.
4 Install the ADCP transceiver as a transceiver channel in the echo sounder user interface.
In this context, the term channel is used as a common term to identify the combination
of transceiver, transducer and operating frequency. The
Transceiver Installation
parameters control the installation and disconnection of transceivers. The
Transceiver
Installation
page is located in the
Installation
dialog box.
5 In the
Normal Operation
dialog box, set the operating parameters.
The purpose of the
Normal Operation
dialog box is to provide you with an overview of
the current transceiver parameters. It also allows you to change these parameters to
match your current operating requirements. When a transducer with acoustic doppler
current profiler (ADCP) functionality is activated on the echo sounder, specific settings
are provided.
6 Fill in and sign the Installation Remarks form, and return it to Kongsberg Maritime.
Related topics
Setting to work, page 86
Installing an ADCP transducer, page 88
Installing transceiver channels, page 91
Installing an ADCP transducer
To use an ADCP transducer with the echo sounder system, the transducer must be "installed"
as a part of the software configuration.
Prerequisites
It is assumed that the echo sounder software has been installed, and that all relevant license
strings have been applied.
Simrad CP200-5C Installation Manual