72
484164/A
The packing nipple, rubber gasket and washers are provided with the transducer. Upon
delivery, they are threaded onto the cable and temporarily secured, normally with
wire wraps.
4
Fasten the end of the fish tape to the transducer cable using electrician’s tape.
5
Pull the cable carefully up through the steel conduit.
Continue until you reach the transceiver.Allow the transducer cable to form a service
loop close to the transducer.
Note
Be careful! Make sure that you do not damage the outer surface of the transducer
cable. If water leaks into a cable, it may damage the transducer beyond repair.
6
Allow the transducer cable to form a service loop close to the transducer.
7
Mount the packing nipple.
8
Tighten the packing nipple with enough force to inhibit water penetration.
When the packing nipple has been tightened, pull each cable to verify that it is fastened
properly. If you can move the cable, you must tighten the packing nipple harder.
9
Seal the top of the steel conduit with a Roxtec (or similar) multi-diameter cable sealing.
Related topics
Installing the transducer, page 57
Drawing file, page 94
Mounting the transducer
When all the preparations have been made, the transducer must be installed into the
mounting frame. If required, additional and more detailed procedures must be provided by
the installation ship yard.
Prerequisites
Before you can do this task, the following prerequisites must be met:
• The mounting frame has been installed.
• The steel conduit is mounted with all installation work finalized.
• The transducer cable is installed.
• A service loop is provided immediately over the transducer body.
Simrad CP200-5C Installation Manual
Summary of Contents for Simrad CP200-5C
