Kongsberg Simrad CP200-5C, Installation Manual

Page: 7 / 110

484164/A
5
About this manual
The purpose of this manual is to present the descriptions and drawings required to install
the CP200-5C transducer.
Target audience
The manual is intended for technical personnel; such as skilled shipyard workers,
electricians, qualified engineers and naval architects. It is assumed that you understand
the general principles of maritime electronic equipment. You must also be familiar with
the installation of electronic and mechanical products. You are expected to have basic
mechanical skills and familiarity with handling of sensitive electronic equipment.
Installation instructions/Installation drawings
The information in this document must be regarded as guidelines and recommendations.
The installation shipyard must design and manufacture the necessary hardware to install the
transducer under the hull.
Note
The installation shipyard must provide all necessary design and installation drawings, as
well as the relevant work standards and mounting procedures.
If required, all documents provided by the shipyard for the physical installation of the
CP200-5C transducer must be approved by the vessel’s national registry and corresponding
maritime authority and/or classification society. Such approval must be obtained before the
installation can begin. The shipowner and shipyard doing the installation are responsible
for obtaining and paying for such approval.
Kongsberg Maritime AS will accept no responsibility for any damage or injury to the
product, vessel or personnel caused by equipment that has been incorrectly installed or
maintained, or by drawings, instructions or procedures that have not been prepared by us.
The outline dimensions of the CP200-5C transducer and the relevant installation items can
be found in the
Drawing file chapter in this manual.
About this manual