Kongsberg M3 Sonar, Reference Manual, Page: 60 / 182

58
922-20297001/1.2
Procedure
1 Click the
Text Label
button.
This button is located on the tool bar.
2 In the sonar view, click the area of interest that you want to label.
3 Click and hold the left mouse button on the label overlay and drag it to a place on the
screen where the text is legible.
4 Label the area of interest.
a Double-click on the label overlay to open an
Edit Text Box
dialog box.
b Enter the desired text into the dialog box.
c Click
OK
when done.
5 If the text you entered does not fit within the text label overlay, you can resize the label
by clicking on the label border, then dragging it to create a larger label.
Tip
To remove this overlay, click the
Wiper
button, then click the overlay.
Related topics
Text Label, page 154
Placing reference cursors
You can place one or two reference cursors as overlays on the sonar view. When you place
two cursors, an additional overlay will appear with information about the cursors.
Context
The Reference Cursor buttons are used to mark points of interest and to
determine the range and bearing of these points (relative to the Sonar Head).
These buttons are located on the tool bar.
Procedure
1 Click the
Reference Cursor 1
button.
M3 Sonar FLS Reference Manual