Kongsberg EM 2040 MKII, Installation Manual

Page: 23 / 248

472405/A
23
Tools, equipment and consumables required
for installation
To install the EM 2040 MKII system, all necessary tools and equipment for mechanical
work, cabinet installation and electrical wiring must be available.
It is not practical to provide a detailed list of all necessary tools and equipment. You must
be equipped with a standard set of tools. This tool set must comprise the normal tools for
electronic and electromechanical tasks. This includes different screwdriver types, pliers,
spanners, a cable stripper, a soldering iron, etc. Each tool must be provided in various
sizes. We recommend that all tools are demagnetized to protect your equipment.
However, you must make sure that the following specialized tools are available.
• All necessary tools and consumables required for welding
• All necessary tools and consumables required for physical installation of transducer
frames and transducer modules
• All necessary tools and consumables required for electrical installations
• Torque wrench
• Unless a suitable lifting device is available, make sure that enough manpower is
available to lift, hold and fasten the transducer.
Note
If you need specific consumables, or if special tools and/or test instruments are required,
these are identified in the relevant procedure(s).
Personnel qualifications
The installation of the EM 2040 MKII system is a demanding task. It is very important
that the personnel involved in the installation tasks are competent and experienced
craftsmen.
As a minimum, the following certified craftsmen must be available.
• Service engineer from Kongsberg Maritime
• Welders
• Electricians
Preparing the installation