Kongsberg EM 2040 MKII, Installation Manual

Page: 227 / 248

472405/A
227
If a unit needs temperature protection, the box to be used for storage and transportation
must be lined on all walls, base and lid, using minimum 5 cm thick polyurethane or
polystyrene foam.
Most system units can normally be stored in temperatures between -30° C and +70° C.
Refer to the relevant technical specifications for details.
Note
Unless otherwise specified, transducers and hydrophones must not be stored in
temperatures below −10°C and above +50°C.
Packing instructions for storage or shipping
If a unit needs to be packed for storage or shipment, you must whenever possible use
its original packing material and/or crate.
Context
In the event that the original packing material is unavailable, observe this basic
procedure. It applies to all cabinets, large or small units, and mechanical items.
Note that a dedicated procedure applies for circuit board handling and packaging.
Any units that requires protection against extreme temperatures are identified as such
in the applicable documentation. The box used to transport and store such units are
clearly marked, for example:
Must not be transported or stored in temperatures below -5 °C.
Other temperature limits may be used if applicable.
If a unit needs temperature protection, the box to be used for storage and transportation
must be lined on all walls, base and lid, using minimum 5 cm thick polyurethane or
polystyrene foam.
Most system units can normally be stored in temperatures between -30° C and +70° C.
Refer to the relevant technical specifications for details.
Note
Unless otherwise specified, transducers and hydrophones must not be stored in
temperatures below −10°C and above +50°C.
Procedure
1 Clean and protect the unit as described in the relevant procedures.
2 Place the unit in a suitable cardboard box or wooden crate.
3 Make sure that the unit is well be protected against physical damage by means of
shock-absorbing insulation mats.
Equipment handling