Kongsberg cNODE MiniS, Instruction Manual

Page: 19 / 62

397152/E
19
3 Place the test transducer face to face with the transponder transducer.
4 Select the
Acoustic test
tab.
5 Type in the serial number, if necessary.
6 Type in the transponder channel number, if necessary.
7 Tap
Interrogate
.
8 A green indicator will flash on the display if there is acoustic contact with the
transponder.
9 Tap
Interrogate
again to stop the acoustic test.
Pre-deployment checks
Before deploying the transponder, it is important to do the following checks to make
sure the operation goes smoothly.
Context
It is recommended to test the transponder with the Test and Configuration unit (TTC) to
make sure it is working properly before operation.
Procedure
1 Make sure the locking cord is in place.
2 If the unit has been altered from the factory pre-sets, check that the unit is
configured according to your requirements.
3 Make sure the battery is fully charged.
4 Push the pressure relief valve in to confirm that it is flush with the end cap.
5 Switch the transponder ON by inserting the on/off plug.
6 Perform an acoustic test using a Transponder Test and Configuration (TTC) unit:
Acoustic test, page 18
a Interrogate the transponder.
b Read battery status and confirm that it will last for the upcoming operation.
c Read the power setting and confirm it is correct for the upcoming operation.
Getting started