Kongsberg cNODE MiniS, Instruction Manual

Page: 17 / 62

397152/E
17
Connecting the transponder to external
power and responder signals
The transponder can also be used as a responder unit.
Prerequisites
The transponder must be charged before use. This is the pin configuration for a male
connector, as seen towards the connector (face view).
1
2
3
4 Responder t
5 Responder trigger -
6 On/Off
7 External power (24 VDC)
8 Ground
Procedure
1 Use the cable with part number 402462 from Kongsberg.
2 Connect wire 6 and 8 in the pigtail (the ON/OFF function).
When 6-8 are linked, the transponder is ON.
With no connection between 6-8, the transponder is OFF.
3 Make sure that the external power supply 24 VDC is between 20 and 28 VDC.
4 Check the responder trigger signal.
5 Switch ON the unit by inserting the external power/responder cable.
Further requirements
It is recommended to test the transponder with the Test and Configuration unit (TTC) to
make sure it is working properly before operation.
Getting started