Kongsberg cNODE Embed, Instruction Manual, Page: 14 / 38

14
429468/B
Procedure
1 Use one yellow wire (0.5 mm
2
) and connect the white wire from the transducer with
both capacitors and the yellow wire from the transformer.
2 Use one red wire (0.5 mm 2 ) and connect the black wire from the transducer with
both capacitors and the red wire from the transformer.
3 Use two black wires (0.5 mm
2
) and connect both to the black wire from the
transformer.
4 Use two blue wires (0.5 mm 2 ) and connect both to the blue wire from the
transformer.
5 Use two green wires (0.24 mm 2 ) and connect both to the green wire from the
transducer.
6 Use one orange wire (0.24 mm 2 ) and connect to the orange wire from the transducer.
7 Add crimp terminals to the end of the wires.
8 Install the crimp terminals in a Molex 8-pin receptacle according to the cable
drawing.
a Connect the green wires to pin 1 and 5 on the receptacle.
b Connect the black wires to pin 3 and 7 on the receptacle.
c Connect the blue wires to pin 4 and 8 on the receptacle.
d Connect the orange wire to pin 6 on the receptacle.
This is now receptacle J1.
9 Connect receptacle J1 to connector P1 on the front of the PCB.
cNODE Embed Instruction Manual