Dipswitch #10 is use to set master or slave mode. Master modes have sound active and
AUTO mode. Slave modes have DMX and Slave mode. The units automatically identify
DMX or SLAVE mode by data receives. Dipswitch #9 use to is set sound active or AUTO
mode in master mode.
DMX address calculation
For DMX mode, DMX address from #1 to 9# dipswitches must be set, the address is set
from 1 to 511. Each dipswitch represents a binary value.
Front Panel Figure
Dipswitch
Value
Dipswitch
Value
1. Laser Aperture
2. Sound Active Microphone
3. Power Indicator:Red
＃
1
1
＃
6
32
4. Sound Active Indicator:Blue. The LED will twinkle when a stimulated sound signal is
＃
2
2
＃
7
64
received form the MIC
5. LED aperture
＃
3
4
＃
8
128
＃
4
8
＃
9
256
＃
5
16
＃
10
DMX, Set to "0"
One unit has 5 channels, so each unit must be assigns 5 channels at least. We may assign 8
channels for one unit, then DMX address = 8*N + 1, N=0, 1, 2, 3 …… Example,
One loop address=1, two loop address=9, three loop address=17, four loop address=25
Loop Address Binary Dipswitches
1 1 100000000
＃
1
2 9 100100000
＃
1+#4
Rear Panel Figure
3 17 100010000
＃
1+#5
1. Dipswitches: Function Setting
2. DMX Signal Indicator: Green. The LED will
4 25 100110000
＃
1+#4+#5
twinkle when DMX or Master-slave
3. Cooling Fan
The dipswitches setting for DMX address see the " DMX Address Quick Reference Chart ".
4. Audio Sensitivity Knob
5. DMX or Linking Jack
6. Switch ON/OFF
7. Power plug
Stand-Alone Operation (Sound Active, AUTO mode)
The mode allows a single unit to react to the beat of the music in the master mode.
Sound Active
1. Install the units in a suitable position (laying or appending).
The change of the laser pattern is controlled by sound, that is, the rhythm of the sound
2. Set dipswitch to select Sound Active or AUTO mode.
control the effect of the changing laser pattern. Turning the sensitivity knob in the clockwise
3. Turn on the unit power, the unit begins reset, then the unit begins working.
direction to increase the fixture’s sensitivity to sound, the knob in the counter clockwise
4. The unit will react to the low frequencies of music via the internal microphone. Adjust
direction to decrease. The laser diode will automatically turn off after 8 seconds when the
the audio sensitivity knob on the back of the unit to make the unit more or less sensitive in
music stops.
sound active.The panel has LED indicating for sound active.
AUTO
Auto cycles the built-in programs without being controlled externally. It has no laser OFF.
Page 6
Page 3
Front/Rear Panel
Operation
Function & Setting
1
2
3
4
1
5
1
2
4
6
7
3
5
