Kompernass QC 360 A1, Operating Instructions Manual

Page: 17 / 112

■ 14 │ GB QC 360 A1
Maintenance, cleaning and repair
Maintenance
There are no mechanical parts that require lubrication or other maintenance.
Cleaning
CAUTION
► To prevent damage, ensure that no moisture can penetrate the interior of
the quadrocopter.
The quadrocopter should be cleaned after every flight to remove any dirt or
debris (wool threads, hairs, dust, etc.).
♦ Use a dry or slightly damp cloth to clean the model and avoid getting any water
on the electronics, rechargeable battery and motors.
Repairs
NOTE
► Replacement batteries can be ordered on the Internet at www.kompernass.com.
If a rotor is damaged due to a crash or other impact, it should be replaced
immediately. This also applies if you notice fine cracks or hairline fractures
in the rotors. Due to the high rotational speed, fragments can detach and fly
off causing damage or putting bystanders at risk. Before assembly, ensure
that you do not mix up the rotors. The quadrocopter has two different rotors
which can be differentiated by the markings (
A
&
B
) on the bottom. The
replacement rotor blades supplied also have different colours (black and
white). To make it easier to identify the direction of flight, you can fit two
black rotor blades at the front and two white rotor blades at the back.
♦ To change a rotor, lever the damaged rotor off the motor shaft using the dismantling
tool supplied and replace it with a new rotor. When doing this, the new rotor may
not be pushed all the way onto the motor shaft. Maintain a distance of approx.
0.5 mm to the motor housing.
♦ Mount the rotors marked with
A
onto the rotor arms marked with an
A
.
Mount the rotors marked with
B
onto the rotor arms marked with a
B
.
A
B
B
A
A
B
B
A