EN
UAB KOMFOVENT we reserve the right to make changes without prior notice
MOU_22-10
14
5. WIRING
Safety Precautions
• Be sure to disconnect the power supply before working on the unit.
• All electrical wiring must be done according to local and national regulations.
• Electrical wiring must be done by a qualified technician. Improper connections
may cause electrical malfunction, injury and fire.
• An independent circuit and single outlet must be used for this unit. DO NOT plug
another appliance or charger into the same outlet. If the electrical circuit capacity
is not enough or there is a defect in the electrical work, it can lead to shock, fire,
unit and property damage.
• Connect the power cable to the terminals and fasten it with a clamp. An insecure
connection may cause fire.
• Make sure that all wiring is done correctly and the control board cover is properly
installed. Failure to do so can cause overheating at the connection points, fire, and
electrical shock.
• Ensure that main supply connection is made through a switch that disconnects all
poles, with contact gap of a least 3 mm (0.118”).
• DO NOT modify the length of the power cord or use an extension cord.
•
Connect the outdoor wires before connecting the indoor wires.
•
Make sure you ground the unit. The grounding wire should be away from gas pipes, water pipes,
lightning rods, telephone or other grounding wires. Improper grounding may cause electrical shock.
DO NOT connect the unit with the power source until all wiring and piping is
completed.
•
Make sure that you do not cross your electrical wiring with your signal wiring, as this can cause
distortion and interference.
Follow these instructions to prevent distortion when the compressor starts:
•
The unit must be connected to the main outlet. Normally, the power supply must have a low output
impedance of 32 ohms.
•
No other equipment should be connected to the same power circuit.
•
The unit’s power information can be found on the rating sticker on the product.
