UAB AMALVA we reserve the right to make changes without prior notice
5
D2-18-01
When unit is loaded or unloaded by crane, cargo rope is fastened in its designated places.
Forklift truck or hand pallet truck can transport air handling unit as it is shown (2 a, b, c
Pictures
).
Vertical and horizontal unit transportation by forklift truck, hand pallet truck or crane
2 a Picture
2 c Picture
2 b Picture
2 a Unit is transported by forklift truck on a wooden pallet;
2 b Unit is transported by hand pallet truck on a wooden pallet;
2 c Unit is lifted by crane on a wooden pallet.
The unit should be examined upon receipt, to ensure that no visible damage has occurred during transit, and
the advice note checked to ensure that all items have been received. If damage or delivery shortages are disco-
vered, the carrier should be immediately informed. AMALVA should be notified within three days of receipt, with
a written confirmation sent within seven days. AMALVA can accept no responsibility for damage by unloading
from carrier or for subsequent damage on site.
If the unit is not to be installed immediately, it should be stored in a clean, dry area. If stored externally, it
should be adequately protected from the weather.
3. BRIEF DESCRIPTION OF THE UNIT
• The air handling units are intended for ventilation of small and medium-sized spaces (eg. single family
houses, offices, etc.), having operating ambient temperature and relative humidity. The unit is intended to
be installed in the domestic or non residential premises. Mineral wool is used for thermal insulation and
sound attenuation. Units cover panels are 25–50 mm thick. As standard, the unit is designed for indoor
placement. In cold, wet rooms possible icing or condensation on the housing inside and outside. The op-
erating temperature range for the unit is -30 °C ... +40 °C, outdoor air temperature. Extracted indoor air
tempe10 – +40 °C, relative humidity (non-condensing) 20–80 %.
• The air handling unit is not to be used to transport solid particles, even not in areas where there is a risk of
explosive gases.
• The units are equipped with a rotary heat exchanger or with a plate heat exchanger (may be replaced with
summer cassette, when recuperation is needless), air filters, an electric or water heater, fans and automa-
tion control system, to ensure safe and efficient operation of the unit.
• Before you open the door, the unit must be switched off and the fans must have been given time to stop (up
to 3 minutes).
• The unit contains heating elements that must not be touched when they are hot.
• We recommend to leave air handling unit in working mode (minimum 20 percent of power) during the first
operation year. Due to moisture in building constructions, condensation may occur inside and outside the
air handling unit. Continuous operation of the equipment will significantly reduce the risk of condensation.
