THANK YOU FOR PURCHASING THE KOMET
SONGWRITER
The Komet
Songwriter
is a real
straightforward and easy to operate amplifier. This
manual is intended to help you “
get to know
“ your Komet
amplifier, and make use of the
many different sounds which it is capable of.
FRONT CONTROL PANEL LAYOUT
( left to right ):
1.
Power Switch:
engages power to amplifier.
2.
Standby Switch:
allow the amplifier to warm up for
60
seconds before engaging the
standby switch to the play position. This action allows for the tubes to heat up to the
proper voltage required for operation and will help prolong the lifespan of your tubes.
3.
Pilot Light:
illuminates when power switch is in “
ON
” position. The pilot light
uses a type
# 47
( 6.3 Volt
) light bulb. For bulb replacement, gently turn the jewel
lens cap counterclockwise and remove. Now the bulb is exposed. Using the tips of
your fingers, gently push and turn the bulb counterclockwise, extract bulb and
replace.
Note:
Your amplifier will continue to operate with no problem with a
shorted bulb or with no bulb at all.
4.
Bass Control:
controls low end bass range frequencies.
5.
Volume Control:
adjusts
( clockwise )
the overall level and gain of the amplifier.
6.
Treble Control:
controls high end treble range frequencies.
7.
Bright Switch:
Three way selector switch
. Middle
position is off,
Down
position
–
slightly bright,
Up
position
–
most bright.
Note:
the brightness factor of this switch,
in either position of brightness, is
very
subtle.
8.
Input
Jack:
accepts standard ¼ inch plug. Input impedance is 1 Megohm.
Copyright 2000-2012, Riverfront Music, L.L.C. d.b.a. Komet
Amplification. May not be reproduced in any form without express written
consent from Riverfront Music, L.L.C. d.b.a. Komet
Amplification.
