.
MAINTENANCE
MAINTENANCE PROCEDURE
EVERY 250 HOURS MAINTENANCE
Maintenance for every 50 hours service should be carried out at the same time.
LUBRICATE SWING CIRCLE
1. Lower the work equipment to the ground.
2. Using a grease pump, pump in grease through the grease
fittings shown by arrows. (2 places)
3. After greasing, wipe off any old grease that was pushed out.
CHECK LEVEL OF BATTERY ELECTROLYTE
Carry out this procedure before operating the machine.
WARNING
Do not use the battery if the battery electrolyte level is below the LOWER LEVEL line. This will accelerate deterioration of the
inside of the battery and reduce the service life of the battery. In addition, it may cause an explosion.
The battery generates flammable gas and there is danger of explosion, do not bring fire or sparks near the battery.
Battery electrolyte is dangerous. If it gets in your eyes or on your skin, wash it off with a large amount of water and consult a
doctor.
NOTICE
When adding distilled water to the battery, do not allow the battery electrolyte to go above the UPPER LEVEL line. If the
electrolyte
level is too high, it may leak and cause damage to the paint surface or corrode other parts.
When adding distilled water in cold weather, add it before starting operations in the morning to prevent the electrolyte from
freezing.
Inspect the battery electrolyte level at least once a month and follow the basic safety procedures given below.
Open cover (1) at the front right side of the machine. The battery
is inside.
When Checking Electrolyte Level from Side of Battery
If it is possible to check the electrolyte level from the side of the battery, check as follows.
4 - 50
