MAINTENANCE
SERVICE PROCEDURE
4-53
CHECK ALTERNATOR DRIVE BELT TENSION, ADJUST
CHECKING
The standard deflection for the drive belt is approx.13 to 16 mm
when pressed by thumb (approx.10 kg) at a point midway
between the drive pulley and alternator pulley.
ADJUSTING
1.
Remove cover mounting bolts (6) (2 places), and remove
the cover.
2.
Loosen bolts and nuts (1), (2), and (5), then turn nut (4)
and adjust the belt tension.
3.
After adjusting, tighten bolts and nuts (1), (2), and (5), to
secure alternator (3) in position.
4.
Reinstall the cover removed in step 1. Confirm that no part
of the cover touches any moving part of the alternator.
REMARK
Check each pulley for damage, wear of the V-groove, and wear of the V-belt. In particular, be sure to check that
the V-belt is not touching the bottom of the V-groove.
If any pulley is defective, ask your Komatsu distributor to replace it.
If any belt has stretched and there is no allowance for adjustment, or if there are cuts or cracks on any belt, replace
both belts at the same time.
When adjusting the V-belt, do not push the tension pulley directly with a steel bar, etc., but put a wood piece, etc.
between the pulley and bar.
After replacing the V-belt, operate for 1 hour, then check and adjust the belt tension again.
Alternator pulley
Drive pulley
Summary of Contents for 76243
