AKI-CDA-MOD-07T | INSTALLATION
3.2
Installation Process
The following is needed:
•
A Phillips/slot screwdriver
1. Unpack and check the delivery. If damage is found, notify the supplier.
Note:
Place the operator panel on a stable surface during installation.
Dropping the panel or letting it fall may cause damage.
2. Use the cut out dimensions that are included on the outline drawing, found in section
and in the
table, to cut a correct opening in the cabinet.
3. Secure the operator panel in position using all the fastening holes and the provided brackets and
screws:
x 4
0.5 - 1.0 Nm
ky
Kollmorgen | July 2013
9
