STEP 1: Assembling the Cage
The numbered white sticker on the mounting disk helps to indicate
the next available slot. Place one Wire Mounting Disk (R090) on
a flat surface and insert Wire (R101) into slot #1 as shown.
You will hear it click into place.
DO NOT INSERT THE WIRE UPSIDE DOWN.
X
Insert the 2 Cones (R127)
on the inside of the cage.
Remove the white
stickers from the
mounting disks.
Secure with an M6 Lock Nut by using the wrench provided.
Do not overtighten as it may damage the cone.
For Tennis Balls Collecting Cage
Being careful not to miss any slots,
continue inserting wires in numeric
order until all 60 slots are full.
Store the 2 extra wires in case
damaged wires need to be
replaced in the future.
For Pickleballs Collecting Cage
Continue inserting wires into
EVERY 2ND SLOT. Store the 32
extra wires in case damaged wires
need to be replaced in the future.
STEP 2: Assembling the Frame
Loosen, but do not remove the
M5 screws on the Y-Joint of
each R249 Upright.
Insert the two R244 U-Handles into the
Y-Joint of both R249 Uprights so the holes line
up and fasten using M5 screws and lock nuts.
DO NOT TIGHTEN SCREWS and MAKE SURE
THE PLASTIC FEET ON THE U-HANDLES ARE
FACING DOWN.
Place the assembled Base on a
flat surface and tighten the six M5
screws to the Y-Joint.
Insert wire #1 from the
complete mounting disk
into slot #1 on the 2nd disk.
Continue in numeric order
until the cage is complete.
