KB-081120
2020 Kolibri USA
Feed Gap Adjustment
KBR-1500
To adjust the bill feed gap, use the instructions below to turn the adjustment screw at the top
of the unit:
Important Note:
The KBR-1500 feed gap adjustment can be sensitive during adjustments. Do not overturn
each adjustment or you may overshoot the optimum gap. We recommend testing with a
stack of bills after each adjustment turn.
a)
Make a 1 dot adjustment turn at a time, then retest.
b)
If the bill feels too loose, tighten the feed gap by turning the adjustment screw
counterclockwise.
c)
If the resistence against the bill feels too strong, loosen the gap by turning the screw
clockwise.
If you are experiencing a high
amount of DB, DD errors or
multiple bills jammed inside
the machine, turn the screw
counterclockwise 1 dot
at a time, then reset.
If tge unit has a hard time
feeding the bills or tears the
bill, turn the adjustment
scree clockwise 1 dot at a
time, then retest.
4.
Guide the bill between the inner rollers during this step; you should feel moderate
resistance as you move the bill back and forth through these rollers. In other words, the
gap between these rollers is wide enough to pass just one bill per count, but narrow
enough to feel a slight tension or friction when pulling the bill out.
0
+2
+3
+1
-2
-1
-3
0
+2
+3
+1
-2
-1
-3
0
+2
+3
+1
-2
-1
-3
