12
To Operate in Fan Only:
Use this function only when cooling is not desired, such as for room circulation or to
exhaust air (remember to open the vent). You can choose any speed you prefer, though
the “Auto” fan speed is not an available option.
In Fan Only mode, you cannot adjust the set temperature.
To Operate in Dry Mode:
In this mode, the air conditioner will operate as a dehumidifier. Because the conditioned
space is closed or sealed, some degree of cooling will continue to occur.
The air conditioner runs at the Low fan speed, which cannot be adjusted.
To Use Timer (Auto Start/Stop) Feature:
To initiate the Auto Start program, press the Timer button when the unit is
off
.
To initiate the Auto Stop program, press the Timer button when the unit is
on
.
Press or hold the Left (Decrease) or Right (Increase) button to change the Auto Time by
½ hour increments up to 10 hours, and then one (1) hour increments up to 24 hours.
The selected time will register in five (5) seconds and the system will automatically
revert back to display the previous temperature setting or room temperature when the
unit is on.
Filter Check Feature:
This feature is a reminder to clean the Air Filter for more efficient operation. The LED
light will illuminate after 250 hours of operation. To reset after cleaning the filter, press
the Filter Check button and the indicator light will turn off.
Digital Display:
Displays the set temperature in degrees Celsius or Fahrenheit while in most modes.
However, while in Fan Only mode, it shows the ambient room temperature.
For directions
to change the display from “F” to “C” please see the
Additional Remote
Functions
section.
Air Directional Louvers:
The 4-way air directional louvers allow you to direct the air flow Up, Down, Left, and Right
throughout the room as needed. To adjust the air directional louvers side to side use the center
handles as you move side to side.
Note: When the unit is powered off, there is no display.
