3
S47J-A-R1 7/03
A
C
D
Brake Levers
COTTER PIN
HUB CAP
WASHER
Step 1.
Remove and discard
protective plastic sleeve from ends of
rear axle.
Step 2.
Position brake assembly
as shown, with brake levers pointing
towards stroller handle (Figure A).
Step 3.
Push both brake assem-
blies onto rear leg tubes at the same
time until spring loaded buttons click
into place (Figure A & B).
NOTE:
If brake assemblies do not
click and hold in place, the spring but-
ton is stuck and not protruding
through the hole in the tube. Use a
screw driver or pliers to move the
button so that it protrudes out of the
hole in the tube.
Step 4.
Slide wheel onto axle
(Figure C).
Step 5.
Slide washer onto axle
(Figure C).
Step 6.
Fit straight part of cotter
pin through hole on axle as shown
(Figure D).
Step 7.
Line up tabs in the hub
cap with slots in the wheel, snap hub
cap into place.
Step 8.
Repeat for second side.
3
TO ASSEMBLE REAR WHEELS:
B
Slide canopy on as shown.
4
TO ATTACH FRONT CANOPY:
REAR AXLE WITH
BRAKE ASSEMBLY
Button
