INSTALLATION
Ø76mm Min.
Bracket
3M Double
sided Tape
Way 2
For Dry Wall
For Sheet
Bracket
Way 1
How to Install the Faucet
□
Install the mounting stud(1) into the faucet body(2)
base. Slide the washer(3) into the groove of the body
through the hoses and mounting stud.
□
Insert the faucet assembly into the mounting hole.
Ensure the bottom of the washer is against the deck.
□
From underside, slide the washer(4) onto the hoses
and mounting stud, and then place the washers(5,
rubber washer is on the top) and nut(6) onto the
mounting stud.
□
Adjust the faucet to a suitable position, tighten the nut
with tool(7) to secure the faucet.
How to Connect the Hoses
□
Tighten the supply hoses(8) onto water supplies. The
hose with blue mark should be connected to cold water.
The hose with red mark should be connected to hot
water.
□
Open hot and cold water supplies. Turn on the faucet.
Flush hot and cold water for about one minute to
remove any debris. Shut off faucet and water supplies.
NOTE:
Supply hoses must not be taut, kinked, or
twisted during installation. If the supply hoses must be
coiled, maintain an inside diameter of minimum Ø76mm.
How to Install the Bracket
NOTE:
1) The bracket must be installed horizontally.
2) Allow adequate clearance for servicing.
□
Way 1: Secure bracket with provided mounting screws.
□
Way 2: Only apply for flat and smooth walls.
1) Clean the bracket backside and installed location of
the wall. Be sure to remove oil, water and dust.
2) After the surface is dry, tear off one paper of the 3M
double sided tape, stick it on the bracket backside, and
press it evenly for a while after bonding.
3) Tear off another paper of the 3M double sided tape.
Ensure the bracket is horizontal and in the right place,
and then paste it onto the wall and press it firmly.
1439190-T2-A
3
8
1
5
4
2
3
6
7
